CDL Oral Simulator

Air brake test

CDL pre-trip air brake test, step by step in order

The examiner will ask about the low-air warning and the service brakes, so say each test as you do it. Here is the sequence from the study material.

The air brake test in order

  1. Check the build-up rate: With the engine at fast idle, pressure on a dual air system should build from 85 to 100 psi within 45 seconds.
  2. Check the governor: The compressor should stop pumping (cut out) at about 125 psi. Fan the brake pedal to lower the pressure; the compressor should start again (cut in) at about 100 psi.
  3. Test the leakage rate: With the engine off, wheels chocked and the parking brake released, press the brake pedal firmly and hold it for one minute. After the first drop, the gauge should not fall more than 3 psi on a single vehicle or 4 psi on a combination vehicle.
  4. Test the low-air warning: With the engine off and the key on, fan the brake pedal to lower the pressure. The warning light and buzzer must come on before pressure drops below 60 psi.
  5. Check that the spring brakes come on: Keep fanning. When pressure falls to about 20 to 45 psi, the parking brake valve should pop out; on a tractor-trailer the tractor protection valve should also close.
  6. Test the parking brake: Set the parking brake and gently pull against it in a low gear. The vehicle should not move.
  7. Test the service brakes: Wait for normal air pressure, release the parking brake, move forward slowly (about 5 mph) and brake firmly with the pedal. The vehicle should stop without pulling to one side or an unusual delay.

Then the final brake check

  1. Final verification: Start the engine, allow air pressure to build, test service brakes, and verify the parking brake.

What the rule says

Under 49 CFR 383.111(b), drivers of vehicles with air brakes must know, among other areas, what low air pressure readings mean and how to do a safe and accurate pre-trip inspection of the air brake system. In the CDL manual's air brake check, the low-air warning must come on before pressure drops below 60 psi, and the spring brakes must come on automatically when pressure falls to about 20 to 45 psi.

Questions to expect

Practice answering these out loud, then check your answers against your CDL manual:

  • What is the maximum acceptable air pressure loss during a leak-down test on a single vehicle?
  • When should the low-air warning device activate?
  • What happens if air pressure in a spring brake chamber is vented accidentally?
  • What does the tractor protection valve do on a combination vehicle?
  • How do you test that the air brake system is working before driving?

Why it matters

A failed air brake inspection can result in total brake loss at road speed. An undetected air leak means the system is losing pressure every second it operates — in heavy traffic or on a downhill, this can be fatal. The low-air warning is the driver's only signal that braking capacity is degrading before complete failure.

Keep going

Sources named in the study material

  • 49 CFR 383.113(a) - Pre-trip vehicle inspection
  • FMCSA 2005 CDL Driver Manual, Section 11 - Vehicle Inspection Test
  • New York State CDL Manual, Section 11 mapping
  • 49 CFR 383.111(b) - Air brake knowledge areas
  • FMCSA 2005 CDL Driver Manual, Section 5 - Air Brakes

This is an independent practice tool, not official instruction. Test rules differ by state, so check your state CDL manual before test day.

Say it out loud, like test day

Reading is not the same as answering an examiner. Try a free practice exam on this topic and get pushed on what you skip.

Start the free exam One free full exam per device. No sign-up.