General knowledge
Cargo Securement: CDL oral exam study guide
Master CDL cargo securement: federal rules, tie-downs, inspection requirements, and test-day cargo questions.
Practice this topic free One free full exam per device, no sign-up.
What the examiner is checking
A CMV driver is legally responsible for ensuring cargo does not shift, fall, or spill while the vehicle is in transit. Cargo that moves can cause a rollover, a jackknife, or debris that kills other drivers. Federal cargo securement rules (49 CFR Part 393, Subpart I) set the minimum standards for every type of cargo — the driver must know the rules before loading and must re-check the cargo after driving.
Step by step
- Before loading: Inspect the cargo box or flatbed for structural damage that could reduce securement strength. Check that tie-down anchor points are not cracked or bent.
- Check cargo weight and balance: Total cargo weight must not exceed the vehicle's gross vehicle weight rating (GVWR). Weight must be distributed so no axle is overloaded and the load is centered or forward of the center of gravity for the vehicle type.
- Count and inspect tie-downs: Verify the correct number of tiedowns for the cargo type and length. Inspect tie-downs for wear, cuts, or damage before use. Each tiedown must be rated for the cargo weight it secures.
- Check edge protectors: Edge protectors must be used where tie-downs contact sharp edges of cargo to prevent the tie-down from being cut.
- Verify blocking and bracing: For loads that cannot be tied down from above (e.g., logs, machinery), verify that front-end structure, bulkheads, or blocking/bracing is in place and properly secured.
- Check cargo covers and containment: Tarps and cargo covers must be secured so they cannot blow off. For bulk commodities, verify that the vehicle's sides and tailgate are secure and will not allow cargo to escape.
- En-route check: Re-check the cargo and its securement within the first 50 miles, then every 3 hours or 150 miles, whichever comes first, and after every break.
Why it matters
Loose cargo is one of the leading causes of road debris incidents in the US. A 50-pound item in the travel lane at 65 mph is lethal. A shifted load changes the vehicle's center of gravity and handling — the most common cause of single-vehicle rollovers in commercial trucks. The driver bears full legal responsibility for cargo securement from the moment they accept the load until delivery.
Sources
- 49 CFR Part 393, Subpart I - Protection Against Shifting and Falling Cargo
- 49 CFR 393.100 - Immobilizing and securing cargo against movement
- 49 CFR 393.106 - Securing cargo and articles on or in vehicles
- FMCSA Cargo Securement Rules (May 2002 Final Rule)
Related topics
Say it out loud, like test day
Reading is not the same as answering an examiner. Rehearse this topic out loud and get pushed on what you skip.