CDL Oral Simulator

Full walk-around

CDL pre-trip inspection checklist: the full walk-around in order

Work around the vehicle the same way every time. A fixed order is how candidates avoid skipping a part under pressure.

The 14 steps in order

  1. Start at the front of the vehicle: approach and assess overall condition visually before touching anything.
  2. Engine compartment check: Inspect belts, fluid levels, battery connections, and obvious leaks.
  3. Front of vehicle: Check headlights, turn signals, grille, bumper, and windshield for cracks or damage.
  4. Cab interior: Verify seat belt function, horn, windshield wipers, mirrors (adjust if needed), and gauge cluster for warning lights.
  5. Left-front wheel area: Check tire condition (tread depth, sidewall damage), wheel and rim condition, and lug nuts.
  6. Left-front axle and brake: From the wheel area, inspect the brake chamber, slack adjuster, air hoses, and brake drum and linings for damage, leaks, and loose or missing parts.
  7. Left side of vehicle: Check running lights, clearance lights, reflective tape, and trailer connection (on combination vehicles).
  8. Rear of vehicle: Inspect tail lights, brake lights, turn signals, reflective devices, and license plate.
  9. Right-front wheel and axle: Mirror the left-front inspection.
  10. Right side of vehicle: Check passenger-side lights, reflective tape, and cargo security (on cargo vehicles).
  11. Under vehicle: Check for fuel, oil, or coolant leaks on the ground.
  12. Rear axle and brake assemblies: Inspect brake chambers, slack adjusters, and air lines.
  13. Coupling/landing gear (combination vehicles): Verify fifth wheel, kingpin, air and electrical connections, and landing gear condition.
  14. Final verification: Start the engine, allow air pressure to build, test service brakes, and verify the parking brake.

Keep the order, stay ready to adapt

  • Memorizing a fixed script but losing the sequence when the examiner asks to skip or repeat an item — maintain a consistent order but be ready to adapt.

Say the defect, not just the part

  • Pointing at parts without explaining what defect is being checked — examiners need to hear the defect word (e.g., 'checking for cracks in the windshield' not just 'windshield').

Keep going

Sources named in the study material

  • 49 CFR 383.113(a) - Pre-trip vehicle inspection
  • FMCSA 2005 CDL Driver Manual, Section 11 - Vehicle Inspection Test
  • New York State CDL Manual, Section 11 mapping

This is an independent practice tool, not official instruction. Test rules differ by state, so check your state CDL manual before test day.

Say it out loud, like test day

Reading is not the same as answering an examiner. Try a free practice exam on this topic and get pushed on what you skip.

Start the free exam One free full exam per device. No sign-up.